Solar Panel Kit

20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking


20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking
20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking
20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking
20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking
20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking
20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking
20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking

20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking  20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking

Maximum Power Point Tracking (MPPT) solar charge controllers are significantly more efficient than the cheaper Pulse Wave Modulation (PWM) solar charge controllers. A true MPPT solar charge controller needs a large transformer coil and capacitors inside, it is a bigger heavier unit and will usually takes at least 100V-150V input. An MPPT solar charge controller in cool conditions can produce 25-30% more battery charging power than a simple PWM controller and you can connect high voltage panels to lower voltage battery banks. By using higher voltage on the panel side will also benefit by less volt drop and can use thinner cables. On large arrays we run everything at 100V - 150V.

EPSolar charge controllers have established themselves for almost 10 years. We are offering their latest EPEver range of excellent value Tracer A series and iTracer MPPT solar charge controllers. Epsolar/ EpEver has passed ISO9001. Cheaper PWM charge controllers are a good low cost solution for small systems only. To fully exploit the potential of MPPT charge controllers, the solar panel array voltage should be substantially higher than the battery voltage and is generally recommended for systems of 100-150W and upwards.

The MPPT controller enables higher PV system voltages which can then reduce cabling costs by allowing for smaller cable cross sectional areas. The MPPT controller will also harvest substantially more power when the solar cell temperature is low (below 45°C), or very high (above 75°C). To calculate which size controller you need, take the peak solar panel watts and divide by the / battery voltage to give the MPPT rated charge current in Amps, for example 150W/12V = 12.5A, therefore a 20A rated charge controller is recommended. Technical - Tracer AN Series 2210AN. Nominal System Voltage 12/24V Auto.

Battery Input Voltage Range 8V 32V. Max Charge/ Discharge Current 20A.

PV Open Circuit Voltage 100V (At minimum operating environment temperature). PV Open Circuit Voltage 92V (At 25 DegC operating environment temperature). MPPT Voltage Range +2V 72V. Max Rated Charging Power (20A), 260W (12V), 520W (24V). PV Array Input Power 780W (12V), 1560W (24V). Wiring Connections, Solar +/-, Battery +/-, Power Output +/-, Temp Sensor, COM RJ45. Working Environment Temperature Range - 25 to +45 DegC. Dimensions 220mm x 154mm x 52mm. Power Terminals 6AWH (12mm sq). Maximum PV Array input power. When the PV array is connected to the charge controller with correct polarity, the Max.

PV Array Power must not exceed three times the Rate Charge Power. These MPPT controllers have a limiting function on charging current to protect the components and circuits.

They will charge the battery(s) within the rated charging power even if PV input power exceeds this range, for example. 1, If the PV array output power is less than or equal to the rated charge power above, the controller will charge the battery(s) at the actual maximum power point.

2, If the PV array output power is greater than the rated charge power above, the controller will charge the battery(s) at the maximum rated power. This should be taken into account when designing the PV array power output which may peak during summer months causing some surplus generation in off-grid systems.

For larger PV arrays, this solar charge controller may only form part of the overall system where some of the power generation is channelled into battery storage and the remainder of power generation may have real time usage/ consumption. This item is in the category "Home, Furniture & DIY\DIY Materials\Electrical Supplies\Alternative Energy Supplies\Solar Power Supplies\Solar Panels & Kits".

The seller is "motorpartners" and is located in this country: CN. This item can be shipped worldwide.

  1. Brand: PowMr
  2. Charging Mode: MPPT (Maximum Power Point Tracking)
  3. Current Output: 20
  4. Current Rating: 20A
  5. Current Type: DC
  6. Model: 2210AN
  7. Power: 701-800 W
  8. Power Source: Solar
  9. Solar Technology: All
  10. System Configuration: Hybrid
  11. Type: Solar Panel Kit
  12. Voltage: 12/24V


20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking  20A EPEver MPPT 12/24V Solar Charge Controller Ultra Fast Power Solar Tracking