200 Watt Monocrystalline Solar Panel with 1M cable & solar connection plugs attached. 5 Metre Solar Power Extension Cable with solar connection plugs. 20A Victron Energy PWM Solar Charge Controller. 1.5m Battery Line Fused 2.5mm2. 4 Corner solar panel brackets.Beat energy inflation, energy security, remote location power sources (save a fortune on armored cabling), mobile power sources, fast payback periods over conventional fuel sources such as diesel generation and hook-ups, keep batteries fully charged at all time as deep discharge shortens life, environmentally friendly power which reduces carbon emissions to slow global warming and climate change. Lightweight design with rigid anodised aluminium alloy frame and toughened glass.
CE, TUV, ISO 9001 quality assurance. Our Monocrystalline panels are 2 to 4% more efficient than polycrystalline.
Monocrystalline Advantages over Cheaper Polycrystalline solar panels. Performs better in lower light levels i. Longest life with lowest rate of performance loss of only 0.36% per year, therefore a 200w panel would be around 182w after 25 years. Performs better on hot summer days. Lower grade silicone 13-16% efficiency.
Performance loss 0.64% per year, therefore a 200w panel would be around 168w after 25 years. Slightly lower heat tolerance than mono crystalline solar panels, i. Excessive heating of the panel causes a reduction in power generation. Sheds, Stables, Boats, Caravans, Motorhomes, electric fencing, road/ path/ driveway illuminated signage, campsites, yurts, multi-panel off grid power source for small buildings, remote telecomms, mobile food outlets, and many more. Independent Off-Grid Solar Power Source.
One or more solar panels can be connected a battery bank and power inverter using a solar charge controller. You can therefore have a 240v power supply anywhere in the world without grid supply.Please see our solar power kits. Solar Panels do still generate power during cloudy and rainy weather! We have a rough guide below to solar panel power output relative to weather conditions. 100% power output - clear sky midday sun with the panel fully tilted toward the sun's position in the sky.
75-85% output - clear sky midday sun but with the panel laid flat. 50-65% output - thin cloud, or intermittent small clouds.
10-20% output - midday overcast sky or rainy conditions. 200 Watt Solar Panel - (with 1m Cable & solar connection plugs). Max Power Voltage: 24.2v. Open Circuit Voltage: 27.1v.
Short Circuit Current: 9.10A. Size: 1310 x 990 x 35mm. Maximum System Voltage: DC1000v (IEC). In the event that the solar panel is in shade for a prolonged period, our solar panels has two built-in bypass diodes which will enable the panel to continue generating.Two 5 Volt USB outputs. Lighting control function, fully programmable. Three stage battery charging (bulk, absorption, float), fully programmable. Load output with low voltage and manual disconnect (programmable). Load output protected against over load and short circuit.
Protected against reverse polarity connection of the solar panels and/or battery. Maximum solar voltage 28V / 55V. Load output Manual control + low voltage disconnect +timer.
Protection: Battery reverse polarity (fuse) Output short circuit Over temperature & Overload protection. Shut down after 60 s in case of 130% load.Shut down after 5 s in case of 160% load. Short circuit: immediate shut down. Range -35 to +60°C (full load). Charge voltage'absorption' Factory setting: 14,4V / 28,8V.
Charge voltage'float' (2) Factory setting: 13,7V / 27,4V. Low voltage load disconnect Factory setting: 11,2V / 22,4V. Low voltage load reconnect Factory setting: 12,6V / 25,2V.Current 2A (total from 2 outputs). Terminal size 6 mm² / AWG10. Dimensions (h x w x d) 96 x 169 x 36 mm. EMC EN 61000-6-1, EN 61000-6-3, ISO 7637-2. 1 For 12V use 36 cell solar panels, For 24V use 72 cell solar panels or 2x 36 cell in series. 2 The controller switches to the lower float voltage level 2 hours after the absorption voltage has been reached. Whenever the battery voltage becomes lower than 13V, a new charge cycle is triggered.
1, make sure your battery has enough voltage for the controller to recognise the battery type before first installation. 2 the battery cable should be as short as possible to minimise loss. 3, this charge controller is only suitable for regulating solar panels.
Never connect another charging source to this charge regulator. Do not install the charge controller in a sealed enclosure where battery gases can accumulate. These charge controllers can be used with one or more 12V batteries where additional storage capacity may be needed, or a combination of series and parallel batteries to make a 24V energy storage system. Please Note We try to dispatch the same day however sometimes this is not possible due to our collection times. Some items due to their size or weight may be unavailable to customers in the Highlands or Islands.To comply with all UK building regulations any electrical work should be carried out by a UK certified electrician. All electricity should be switched off prior to ANY electrical work being carried out. Please do not book any qualified tradespersons until goods are in hand. Low Energy Supermarket is a certified carbon neutral plus company and was founded in 2010. We are a family run business based in Cheshire, UK. We offer various energy saving products which will help to reduce the ever rising energy bills. We only offer quality products and bring these to you at the most competitive prices we can. Low Energy Supermarket was founded in 2010, we offer various energy saving products which help to reduce the ever rising energy bills. We only offer quality products at a competitive price. 99% of customers would recommend us to a friend. This item is in the category "Home, Furniture & DIY\DIY Materials\Electrical Supplies\Alternative Energy Supplies\Solar Power Supplies\Solar Panels & Kits". The seller is "lowenergysupermarket" and is located in this country: GB. This item can be shipped to United Kingdom.